Soil Preparation and Analysis
|
Subject: Raising PPM with good balance
|
|
From
|
Location
|
Message
|
Date Posted
|
Holloway |
Bowdon, GA
|
My spring soil test says balance and Ph are very good for melons, however the PPMs are lower in some areas than I usually have. I would like Ca, Mg, and K higher. Without raising ph higher, gypsum, mag sulfate, and potassium sulfate get me there still in balance. However this would push sulfur levels way up. I think if my calculations are right the end result would be sulfur around 600 ppm. Is that too high? Any other suggestions to raise CA,Mg,K without raising ph?
|
4/6/2016 8:37:26 PM
|
Condo* |
N.c.
|
600 ppm S did not seem to bother my pumpkin and bushel gourd plants in sandy loam.
|
4/7/2016 9:41:14 AM
|
Christopher24 |
aurora, IL
|
Adding gypsum will raise Ca and maybe Mg, but not pH.
|
4/7/2016 1:55:11 PM
|
HankH |
Partlow,Va
|
don't worry about the sulfer levels here in the east H2O is naturally acidic and will do the job
|
4/7/2016 10:44:51 PM
|
Holloway |
Bowdon, GA
|
I have a clay loam soil so I'm not sure how fast the sulfur will leach. I know some people's sulfur is high but I was concerned at high levels it might effect beneficial fungi. Sulfur is used as a fungicide wasn't sure what happens at high levels. My ph is where I want it so I'm trying to avoid lime. Gypsum, mag sulfate, and potassium sulfate won't raise ph but I would be triple dosing the sulfur. Thanks for the answers.
|
4/7/2016 11:11:18 PM
|
Condo* |
N.c.
|
Hey Holloway! I do not know the answer to your question, but from what I been able to find so far 20 ppm S might be close to ideal for mycorrhizal fungi. So just speculating here....600 ppm S is probably way too much. Last year I tried a few of the products from NPK Industries Raw Soluble line of plant nutrients. I was really impressed and I will be using a lot more of their products this year.
|
4/8/2016 8:21:56 AM
|
Holloway |
Bowdon, GA
|
Thanks Condo, I think I can get a little higher on ph after seeing some other melon growers did well at those levels so I will try to get as close as I can with lime and finish it off with sulfates.
|
4/8/2016 9:34:21 AM
|
cntryboy |
East Jordan, MI
|
600 ppm (or more) of sulfur has never hurt us here. The plants need and use a lot of sulfur.
|
4/8/2016 5:34:22 PM
|
Holloway |
Bowdon, GA
|
Thanks Cecil
|
4/12/2016 10:08:13 PM
|
Total Posts: 9 |
Current Server Time: 11/23/2024 6:21:30 PM |